What is Dermabrasion?

Dermabrasion is a method of peeling off the top most layer of damaged skin with the use of a power-driven diamond wheel with coarse edges referred to as a fraise or a burr. Others prefer using a wire brush. Either of these two hand-held gadgets is operated in a brisk rotating manner in peeling off and smoothening out the outer layer of the skin. Beforehand, a local or general anaesthetic is applied depending on the area of the skin that needs treatment. The skin also needs to be thoroughly cleansed with an antiseptic before the procedure can begin to prevent complications. In the process of dermabrasion, the skin gets injured and bleeds. However, as the wound begins to heal, fresh new skin grows in place of the flawed skin. The procedure lasts from several minutes to a couple of hours to complete depending on the extent of skin damage.

What is microdermabrasion?

It is the process in which various but similar devices are used in breaking or loosening the outermost layers of the skin which is called the stratum corneum.  During microdermabrasion, instruments are passed over the skin usually three times making use of crystals in chafing off dead skin cells while at the same time sucking it off of the skin. This results in the bruising of the skin and gives signals to the body that there is an injury so that new healthy cells are regenerated to replace the dead ones.  The whole process takes less than an hour and while redness and a little swelling appear, this lasts only a few hours. The procedure causes little pain and discomfort or none at all. It removes damaged skin cells caused by sun exposure and skin blemishes. With the removal of the stratum corneum, the skin is left clearer and smoother.

What is dermabrasion as compared to microdermabrasion?

While dermabrasion makes use of the fraise or brush, microdermabrasion uses a similar instrument that is not as hard on the skin and does not hurt as much if at all. The hand-held instrument sprays the skin with crystals that exfoliates the top most layers. Both procedures have the same objective – to have healthier looking skin. Microdermabrasion, however, is a milder method that does not injure the skin. You can experience a redness or swelling but this does not last long. It is an easy procedure which can be done either at a clinic or right at home. It replaces dead skin cells with healthy new ones. Skin imperfections can come in the form of sun damage, blemishes, scarring and fine lines. While initial treatment can remove all these, continued use of products will eventually peel off deeper skin blemishes over time leaving you with a healthy, glowing, beautiful skin.

What is dermabrasion as compared to diamond microdermabrasion?

Competition of trying to come up with other methods of rejuvenating the skin brought about the innovation of the diamond microdermabrasion process. Instead of spraying the skin with crystals which is still quite popular and safe, individuals can use this alternative method in the removal of skin imperfections. Compared to dermabrasion which causes injury to the skin, this process hardly hurts the skin. It makes use of a hand-held wand-like gadget with a tip covered in minuscule diamonds. When the tip touches the skin it chafes against the outer most layer and loosens it. The instrument then sucks the ruffled dead cells away from the skin. This is done by passing the instrument three times over the treatment area.

Comparison of Microdermabrasion vs Chemical Peel

Both procedures involve the exfoliation of dead skin cells and replacing it with new and healthy ones. While microdermabrasion eliminates minor skin imperfections like sun damaged skin, skin blemishes and small scars, chemical peel works on deeper skin problems like wrinkles and deep scarring. In comparing microdermabrasion vs chemical peel, the procedure for chemical peel requires a longer period for healing and after care. The method also causes much discomfort and may require an anaesthetic especially if a deeper strength is used. On the other hand, microdermabrasion does not hurt and causes no downtime. And while it initially eliminates minor skin problems, continued use over time also eliminates wrinkling and major scarring.

Microdermabrasion Cloth – A Natural Way of Rejuvenating your Skin

Microdermabrasion cloth is a consolidation of materials such as polyester and nylon that are intertwined together in such a way as to maximize their function at exfoliating damaged skin cells. The cloth contains thousands of tiny fibers which work well at removing damaged skin cells leaving your skin looking smoother and clearer. It is also useful in the removal of dirt, oil, makeup and bacteria that may have accumulated in the skin. As compared to home kits, it is considerably easier to use and less expensive. Here are some tips on how to use cloth to maximize its effectiveness:

• Before using the cloth, make sure you cleanse your face with water and using either an anti-bacterial or mild soap.

• Next, lightly tap your face dry with a face towel. Then, dampen the cloth with lukewarm water and build up a lather using a mild anti-bacterial soap.

• Rub the cloth gently around you face in a circular fashion beginning with your nose and moving outwards for no more than two minutes. This should be done with care as your facial skin is so sensitive.

• Rinse off and pat your face dry either with a soft cotton pad or towel.

• If you plan to go outdoors, do not forget to put on a sunscreen lotion for protection.

At present there are numerous ways of keeping your skin looking youthful, glowing and smoother. Microdermabrasion is one method that is proven to be effective, popular and safe. There are many products to choose from. You can go to a professional skin specialist or you can do it yourself right at home. It is a very convenient and painless method of having great looking skin.


Leave a Reply